Axis 950 Instrukcja Użytkownika Pobierz pdf (Strona 62)

Appendix C: Updating the Software

62 AXIS 850/950 User’s Manual



Updating the Axis

CD-ROM server

Flash Memory

You can carry out an update to your Flash memory over the network

using FTP on a TCP/IP network.

To upgrade over the network you will need the following:

• The file with the new print server software. The name of this file

is on the form product.version, e.g. 850.210 for the software

release 2.10 for the AXIS 850 CD-ROM server. Retrieve the

updated file from Axis (http://www.axis.se/) or your local

distributor.

• A computer on the network with TCP/IP and a FTP.

• The CD-ROM server must also be installed on the network with

TCP/IP as described in the section 3, Network Configuration.

Follow the steps below to upgrade the print server software:

1. Log in to the Axis CD-ROM server with the command

ftp

where <host name> is the name assigned in

your system host table.

2. You will be prompted for user id and password. Use the user id

root, which has the default password pass (root is the user id

with the highest priority).

3. Issue the command binary to change to binary transfer mode.

4. Issue the command

put <software name> flash where

<software name> is the name of the new CD-ROM server

software, e.g.

850.210.

5. Wait for the Flash load to finnish. This normally takes 1 to 4

minutes. The unit will then automatically restart with the new

print server software.

Caution ❏ Be careful not to interupt the file transer. If the transfer is

interuppted the CD-ROM server may have to be re-initialized by

your dealer.

6. Log out using the command

quit, bye or exit depending on

your FTP version.

Instructions on how to carry out the update are also supplied with the

software update.



1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68 69

Komentarze do niniejszej Instrukcji

Brak uwag

Axis 950 Instrukcja Użytkownika Strona 62

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Serwery Axis 950