Axis BTA 2100D Instrukcja Operatora Pobierz pdf (Strona 41)

100

101

The Instrument menu is displayed. Press 1 to select the Remote/ Local Control

screen. The Ethernet address, IP address and Alias (which may not yet be

assigned) are displayed.

ACTIVE

METHOD

EDIT

METHOD

CTRL RUN

TIME

END

TIME

Method 1 Method 1 0.00 20.00

REMOTE / LOCAL CONTROL

Enable

Ethernet Address: XX:XX:XX:XX:XX:XX

IP Address: XXX.XXX.XX.XXX

Alias: 3800A

  

Use the Ethernet address shown here when setting up the BOOTP Server. The IP

Address and Alias (host name) are assigned by the BOOTP Server.

If the BOOTP Server that you are using automatically updates its table with

Ethernet addresses broadcast by devices on the network, then the Ethernet

addresses from 3800 and 3900 GCs connected to your network and powered on

will automatically appear. Note that the frequency with which these addresses

are broadcast by the GC decreases over time to a maximum rate of once per

minute. This means that the BOOTP Server may not receive an Ethernet

address for up to a minute from any given GC.

If you are using a 3800 GC on a 2000R system and the BOOTP Server that you

are using does not automatically update its table with Ethernet addresses

broadcast by devices on the network, then the Ethernet address can be obtained

from the label on the Ethernet card in the 3800 GC.

Once you have entered the Ethernet address for each GC on the network to the

BOOTP Server, power each GC off then on again. Check that the IP address

shown on the front panel of each GC (in the Remote/Local Control screen)

matches the intended address entered into the BOOTP Server. If they do not

match, verify the Ethernet address, updating the BOOTP Server if necessary.

Powering the GC off and on will update the IP address.

NOTE: When IP addresses are managed from central location by a Network

Administrator, the BOOTP Server on your workstation must be disabled. Verify

that the Manage IP addresses from this Workstation is unchecked in the Setup

Ethernet Ports dialog box.

Using a Password to Protect BOOTP Settings

You may wish to restrict access to the BOOTP Server dialog box to avoid

inadvertent or unauthorized changes to IP address assignments. To do so,

enable password protection in the BOOTP Server dialog box. If the Setup

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 596 597

Komentarze do niniejszej Instrukcji

Brak uwag

Axis BTA 2100D Instrukcja Operatora Strona 41

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Axis BTA 2100D