Axis BTA 2100D Instrukcja Operatora Pobierz pdf (Strona 44)

100

101

This 3800 GC is connected to Port 44. The status indicates the availability of the GC.

The IP address of the GC is shown here. Click OK, and wait for the 3800 to connect.

When the GC connects to System Control, it will be represented by an icon at the

bottom of the Configuration Window. The icon will have a label reading 3800.44,

and will include the Host Name of the GC appended to the label. The number 44

is a System Control communication addresses that correspond to the Ethernet

port connected to the device. The same principles are true for the 3900 GC.

Modules and Instruments Defined

The Varian MS system consists of two modules, the 3800 GC and the 2000 MS.

Additionally, a third module is present if you have the 8200 AutoSampler (Note

that the CP-8400 and CP-8410 AutoSamplers will not have a separate icon but

will be included on the 3800 or 3900 Status and Control Window). These

modules also have addresses and the message logs frequently refer to the

module and address. The modules and allowed addresses are listed below.

Module Name Address

Mass Spectrometer 2000 40

Gas Chromatograph 3800 44

AutoSampler 8200 26

Other communication addresses are used for different types of communication

hardware: 16,18,20,22 for Varian ADC Boards; 17,19,21,23 for Varian 3400 and

3600 GCs, and 24 - 39 for Serial Port devices.

If an 8200 AutoSampler is attached to the J4-SID1 connector on the 3800 GC,

the 8200 icon will also appear with the Host Name of the corresponding GC

appended to the label.

NOTE: Refer to the 8200/SPME AutoSampler for 3800 GC Manual for

information about configuring your 8200 for use with the 3800 GC.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 596 597

Komentarze do niniejszej Instrukcji

Brak uwag

Axis BTA 2100D Instrukcja Operatora Strona 44

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Axis BTA 2100D